supp:seeeduino:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
supp:seeeduino:start [2016/06/21 08:21] – admin | supp:seeeduino:start [2016/06/21 08:23] – admin | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Notes on Seeeduino Boards ====== | ====== Notes on Seeeduino Boards ====== | ||
- | ===== Stalker | + | ===== Seeeduino |
+ | |||
+ | http:// | ||
+ | |||
+ | ==== Power Down, RTC Interrupt and Tipping Bucket Rain Gauge ==== | ||
Some of you are using Seeeduino Stalker V3 boards.The main source of information is the wiki: \\ | Some of you are using Seeeduino Stalker V3 boards.The main source of information is the wiki: \\ | ||
Line 38: | Line 42: | ||
The final result is the rain intensity or more precisely volumetric flow rate (e.g. in mm³/min) over time. | The final result is the rain intensity or more precisely volumetric flow rate (e.g. in mm³/min) over time. | ||
- | ==== Sample Code ==== | + | === Sample Code === |
This UNTESTED CODE :!: includes | This UNTESTED CODE :!: includes | ||
Line 49: | Line 53: | ||
Download :!: : {{: | Download :!: : {{: | ||
- | ===== Wireless Data Transmission with RF-Bee | + | ==== Wireless Data Transmission with RF-Bee ==== |
You can transfer data between two RF-Bees, i.e. one on the Stalker (or another Arduino), the other at the receiving gateway (server, PC, Raspberry PI, ...). | You can transfer data between two RF-Bees, i.e. one on the Stalker (or another Arduino), the other at the receiving gateway (server, PC, Raspberry PI, ...). | ||
Line 77: | Line 81: | ||
* solder jumper P5: BEE_RXD ← D7 (soft UART TX) | * solder jumper P5: BEE_RXD ← D7 (soft UART TX) | ||
- | ==== Hardware Bug ==== | + | === Hardware Bug === |
There are two hardware bugs on Seeeduino Stalker V3 related to solder jumpers P6 (BEE_TXD) and P5 (BEE_RXD). Because of that just closing the solder jumpers as described [[http:// | There are two hardware bugs on Seeeduino Stalker V3 related to solder jumpers P6 (BEE_TXD) and P5 (BEE_RXD). Because of that just closing the solder jumpers as described [[http:// | ||
Line 88: | Line 92: | ||
- | ==== Configuration ==== | + | ==== RF-Bee |
to be done | to be done | ||
supp/seeeduino/start.txt · Last modified: 2017/10/17 11:36 by admin