Differences

This shows you the differences between two versions of the page.

--- supp:seeeduino:start [2016/06/21 08:22] – admin
+++ supp:seeeduino:start [2016/06/21 08:23] – admin
@@ Line 1: / Line 1: @@
 ====== Notes on Seeeduino Boards ======
-===== Seeeduino Stalker 3.0: Power Down, RTC Interrupt and Tipping Bucket Rain Gauge =====
+===== Seeeduino Stalker v3 =====
+http://www.seeedstudio.com/wiki/Seeeduino-Stalker_v3
+==== Power Down, RTC Interrupt and Tipping Bucket Rain Gauge ====
 Some of you are using Seeeduino Stalker V3 boards.The main source of information is the  wiki: \\
@@ Line 38: / Line 42: @@
 The final result is the rain intensity or more precisely volumetric flow rate (e.g. in mm³/min) over time.
-==== Sample Code ====
+=== Sample Code ===
 This UNTESTED CODE :!:  includes
@@ Line 49: / Line 53: @@
 Download :!: : {{:supp:arduino:seeeduino_stalker:stalker_v3_powerdown_rtc_rfbee_sdcard_v002.zip|}}
-===== Wireless Data Transmission with RF-Bee =====
+==== Wireless Data Transmission with RF-Bee ====
 You can transfer data between two RF-Bees, i.e. one on the Stalker (or another Arduino), the other at the receiving gateway (server, PC, Raspberry PI, ...).
@@ Line 77: / Line 81: @@
   * solder jumper P5: BEE_RXD ← D7 (soft UART TX)
-==== Hardware Bug ====
+=== Hardware Bug ===
 There are two hardware bugs on Seeeduino Stalker V3 related to solder jumpers P6 (BEE_TXD) and P5 (BEE_RXD). Because of that just closing the solder jumpers as described [[http://www.seeedstudio.com/wiki/Seeeduino-Stalker_v3#PCB_Jumper_Pads|here]] will not work!
@@ Line 88: / Line 92: @@
-==== Configuration ====
+==== RF-Bee Configuration ====
 to be done