bbtt:distedu:amc2020:material:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| bbtt:distedu:amc2020:material:start [2020/05/19 09:23] – old revision restored (2020/04/22 10:43) admin | bbtt:distedu:amc2020:material:start [2021/01/23 10:53] (current) – removed rolf | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Material for AMC 2020 ====== | ||
| - | |||
| - | * Item 1 | ||
| - | * Item 2 | ||
| - | |||
| - | - Number | ||
| - | - Number | ||
| - | |||
| - | |||
| - | [[https:// | ||
| - | |||
| - | * Arduino UNO R3 or Clone | ||
| - | * USB Cable | ||
| - | * Breadboard | ||
| - | * Jumper Cable (MM, MF, FF) | ||
| - | * LEDs | ||
| - | * R220 for LEDs | ||
| - | * 1k | ||
| - | * 10k | ||
| - | * 100k | ||
| - | * 1M | ||
| - | * LDR | ||
| - | * Ceramic Capacitor 1 UF, wired, through hole | ||
| - | * Potentiometer, | ||
| - | * | ||
| - | * DHT22 or DHT11 | ||
| - | * Buttons for breadboard | ||
| - | |||
| - | * PIR | ||
| - | * Accelerometer (GY-521 breadout board with MPU6050) | ||
| - | * Angular encoder | ||
| - | |||
| - | * OLED 1.3" (1103?), I2C, 3V & 5V | ||
| - | * OLED 0.96" (SDD 1306?), I2C, 3V & 5V | ||
| - | |||
| - | * Display? LED 16x2? | ||
| - | * Adapter, Interface, LED 16x2 -> I2C | ||
| - | |||
| - | * ESP32 (Wifi, BLE), Espressif Dev-Kit 4, Wrover-Module | ||
| - | |||
| - | * RTC module | ||
| - | |||
| - | * 3.3V? 5V??? | ||
| - | * Power switching: Arduino-Relay | ||
| - | * MOSFET, N-Fet, BJT 2N2222, low side current switch | ||
| - | * Diodes, 1N4007??? 1N4148, BAT35???? | ||
| - | |||
| - | * Power supply for breadboard | ||
bbtt/distedu/amc2020/material/start.1589880188.txt.gz · Last modified: 2020/05/19 09:23 by admin