Differences

This shows you the differences between two versions of the page.

--- workshops:nvidia_jetson:xavier_nx:case_assembly [2021/02/19 12:33] – harley01
+++ workshops:nvidia_jetson:xavier_nx:case_assembly [2021/02/21 14:07] (current) – harley01
@@ Line 1: / Line 1: @@
 ====== Jetson Xavier NX Case Assembly (without external antennas) ======
-A few days ago I (Harley Lara) received a NVIDIA Xavier NX development kit from HSRW (Prof. R. Becker) to experiment a little bit.
 The [[https://www.waveshare.com/jetson-nano-case-c.htm|metal case (C) by Waveshare]] (No. 17855) was made for a **Jetson Nano** but it can be perfectly used for a **Xavier NX** as they have the same dimensions. [[https://www.waveshare.com/wiki/Jetson_Nano_Case_(C)|The official tutorial]] to assemble the case is useful but it is necessary to make a small change because the assembly kit does not include the external antennas so it is necessary to adapt the ones included in the Xavier NX.
@@ Line 16: / Line 14: @@
 **Step 1**
-Remove the screws that hold the plate to the plastic base.
-{{workshops:nvidia_jetson:xavier_nx:xavier-assemble-01.jpg?nolink&600|}}
-**Step 2**
 Disconnect the antennas from the wireless network card.
 {{workshops:nvidia_jetson:xavier_nx:xavier-assemble-02.jpg?nolink&600|}}
+**Step 2**
+Remove the screws that hold the plate to the plastic base.
+{{workshops:nvidia_jetson:xavier_nx:xavier-assemble-01.jpg?nolink&600|}}
 **Step 3**
@@ Line 40: / Line 38: @@
 **Step 7**
-Put the push buttons in place.
+Put the push buttons in place, the four-wire button goes in the POWER position and the two-wire button in the RESET position.
 {{workshops:nvidia_jetson:xavier_nx:xavier-assemble-09.jpg?nolink&600|}}