workshops:nvidia_jetson:xavier_nx:case_assembly
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
workshops:nvidia_jetson:xavier_nx:case_assembly [2021/02/11 21:30] – ↷ Links adapted because of a move operation rolf | workshops:nvidia_jetson:xavier_nx:case_assembly [2021/02/21 14:07] (current) – harley01 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Jetson Xavier NX Case Assembly ====== | + | ====== Jetson Xavier NX Case Assembly |
- | + | ||
- | A few days ago I (Harley Lara) received a NVIDIA Xavier NX development kit from HSRW (Prof. R. Becker) to experiment a little bit. | + | |
The [[https:// | The [[https:// | ||
Line 16: | Line 14: | ||
**Step 1** | **Step 1** | ||
- | Remove the screws that hold the plate to the plastic base. | ||
- | {{workshops: | ||
- | |||
- | **Step 2** | ||
Disconnect the antennas from the wireless network card. | Disconnect the antennas from the wireless network card. | ||
{{workshops: | {{workshops: | ||
+ | |||
+ | **Step 2** | ||
+ | Remove the screws that hold the plate to the plastic base. | ||
+ | {{workshops: | ||
**Step 3** | **Step 3** | ||
Line 40: | Line 38: | ||
**Step 7** | **Step 7** | ||
- | Put the push buttons in place. | + | Put the push buttons in place, the four-wire button goes in the POWER position and the two-wire button in the RESET position. |
{{workshops: | {{workshops: | ||
workshops/nvidia_jetson/xavier_nx/case_assembly.1613079046.txt.gz · Last modified: 2021/02/11 21:30 by rolf