workshops:nvidia_jetson:jetson:playground:rolf:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
workshops:nvidia_jetson:jetson:playground:rolf:start [2021/03/20 19:59] – [Jetson AI Fundamentals] rolf | workshops:nvidia_jetson:jetson:playground:rolf:start [2021/03/20 22:54] – [First camera test: video-viewer] rolf | ||
---|---|---|---|
Line 8: | Line 8: | ||
* Install JetPack 4.5.1 on SD card | * Install JetPack 4.5.1 on SD card | ||
- | * | + | * Get the right Docker container. The list of different software combinations can be found here: \\ https:// |
+ | {{https:// | ||
+ | //Fig.: JupyterLab Interface.// | ||
+ | ==== Get / run Docker Image ==== | ||
+ | |||
+ | ===USB Cam Version=== | ||
+ | < | ||
+ | sudo docker run --runtime nvidia -it --rm --network host \ | ||
+ | --volume ~/ | ||
+ | --device /dev/video0 \ | ||
+ | nvcr.io/ | ||
+ | |||
+ | # PW: dlinano | ||
+ | </ | ||
+ | |||
+ | |||
+ | |||
+ | ===CSI Cam Version=== | ||
+ | < | ||
+ | # Two CSI cams version! video0, video1 | ||
+ | sudo docker run --runtime nvidia -it --rm --network host \ | ||
+ | --volume ~/ | ||
+ | --volume / | ||
+ | --device /dev/video0 \ | ||
+ | --device /dev/video1 \ | ||
+ | nvcr.io/ | ||
+ | | ||
+ | # PW: dlinano | ||
+ | </ | ||
+ | |||
+ | ==== Change Keyboard Configuration on Console. Important! ==== | ||
+ | |||
+ | Before you change the boot target (aka runlevel) to multi-user.target, | ||
+ | |||
+ | Open a terminal window and execute '' | ||
+ | |||
+ | Test it on a tty terminal, too, because that is what you get if you change the runlevel to other than graphical. | ||
+ | |||
+ | Press ''< | ||
+ | |||
+ | ==== Change target / runlevel ==== | ||
+ | |||
+ | < | ||
+ | systemctl get-default | ||
+ | |||
+ | # change target of current session | ||
+ | systemctl isolate multi-user.target | ||
+ | # systemctl isolate graphical.target # Use this to get back to graphical mode | ||
+ | |||
+ | # set default target | ||
+ | systemctl set-default multi-user.target | ||
+ | # systemctl set-default graphical.target # Use this to get back to graphical mode | ||
+ | |||
+ | </ | ||
- | ===== Kitchen Experiments (2021-01-27) ===== | + | ====== Kitchen Experiments (2021-01-27) |
Line 48: | Line 101: | ||
video-viewer csi://0 & video-viewer csi:// | video-viewer csi://0 & video-viewer csi:// | ||
+ | # External USB cam is enumerated as video2 | ||
video-viewer v4l2:/// | video-viewer v4l2:/// | ||
</ | </ |
workshops/nvidia_jetson/jetson/playground/rolf/start.txt · Last modified: 2021/04/04 12:02 by rolf