workshops:nvidia_jetson:jetson:playground:rolf:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
workshops:nvidia_jetson:jetson:playground:rolf:start [2021/03/20 20:14] – [Running the 'Hello AI World' Examples (Repo jetson-inference)] rolf | workshops:nvidia_jetson:jetson:playground:rolf:start [2021/03/20 22:51] – [CSI Cam Version] rolf | ||
---|---|---|---|
Line 8: | Line 8: | ||
* Install JetPack 4.5.1 on SD card | * Install JetPack 4.5.1 on SD card | ||
- | * | + | * Get the right Docker container. The list of different software combinations can be found here: \\ https:// |
+ | {{https:// | ||
+ | //Fig.: JupyterLab Interface.// | ||
+ | ==== Get / run Docker Image ==== | ||
- | * Get the right Docker comtainer: \\ https:// | + | ===USB Cam Version=== |
- | + | ||
- | + | ||
- | USB Cam Version: | + | |
< | < | ||
sudo docker run --runtime nvidia -it --rm --network host \ | sudo docker run --runtime nvidia -it --rm --network host \ | ||
--volume ~/ | --volume ~/ | ||
- | --device /dev/video0 \ | + | --device /dev/video0 \ |
nvcr.io/ | nvcr.io/ | ||
+ | # PW: dlinano | ||
</ | </ | ||
- | CSI Cam Version: | + | |
+ | ===CSI Cam Version=== | ||
< | < | ||
+ | # Two cameras version! video0, video1 | ||
sudo docker run --runtime nvidia -it --rm --network host \ | sudo docker run --runtime nvidia -it --rm --network host \ | ||
--volume ~/ | --volume ~/ | ||
--volume / | --volume / | ||
- | --device /dev/video0 \ | + | --device / |
+ | --device / | ||
nvcr.io/ | nvcr.io/ | ||
+ | | ||
+ | # PW: dlinano | ||
+ | </ | ||
+ | |||
+ | ==== Change Keyboard Configuration on Console. Important! ==== | ||
+ | |||
+ | Before you change the boot target (aka runlevel) to multi-user.target, | ||
+ | |||
+ | Open a terminal window and execute '' | ||
+ | |||
+ | Test it on a tty terminal, too, because that is what you get if you change the runlevel to other than graphical. | ||
+ | |||
+ | Press ''< | ||
+ | |||
+ | ==== Change target / runlevel ==== | ||
+ | |||
+ | < | ||
+ | systemctl get-default | ||
+ | |||
+ | # change target of current session | ||
+ | systemctl isolate multi-user.target | ||
+ | # systemctl isolate graphical.target # Use this to get back to graphical mode | ||
+ | |||
+ | # set default target | ||
+ | systemctl set-default multi-user.target | ||
+ | # systemctl set-default graphical.target # Use this to get back to graphical mode | ||
+ | |||
</ | </ | ||
workshops/nvidia_jetson/jetson/playground/rolf/start.txt · Last modified: 2021/04/04 12:02 by rolf